New Universal Solid State E8012S Series Electric Fuel Pump features advanced technology. Exclusive design provides increased vapour handling capacity. Solid state engineering has no electrical contact points to wear out and it is highly resistant to voltage spikes, even reversed polarity. Permanently sealed construction with no screws to loosen or leak. Impervious to corrosion from alcohol blended fuels. Available for both domestic and import carbureted applications.

The Walbro high output in-tank electric fuel pumps are available in flow ratings of 255 litres of fuel per hour. These particular pumps flow significantly more fuel at higher pressure. For example, at 80 PSI the standard 255 lph pump will flow around 132 litres per hour. At that same 80 PSI the equivalent HP (high pressure) fuel pump will flow over 210 litres (50 gallons) per hour.

Walbro in-tank electric fuel pumps utilise a proven gerotor design. The outside dimensions, however, are compact enough to fit existing hanger assemblies, with little modification.

For applications where low cost and durability are required.

• Flow: to 190 lph (52 gph)
• Continuous duty life (diesel fuel): > 5000 hrs
• Weight: 0.74 kg (1.63 lbs)
• Pump cycles continuously when power is on

For applications where battery life, low noise and durability are important and fuel quality is questionable.

• Flow: to 160 lph (35 gph)
• Ampere hours: up to 70% less than FRA & FRC
• Continuous duty life (diesel fuel):>18000 hrs
• Weight: 0.83 kg (1.83 lbs)
• Pump cycles only when fuel is demanded
• Replaceable filter

For applications where low costs and better durability are important and fuel quality is questionable.

• Flow: to 210 lph (55 gph)
• Continuous duty life (diesel fuel):>10000 hrs
• Weight: 0.83kg (1.83lbs)
• Pump cycles continuously when power is on
• Replaceable filter

For applications where battery life, low noise and durability are important.

• Flow: to 210 lph (55 gph)
• Ampere hours: up to 70% less than FRA & FRC
• Continuous duty life (diesel fuel):>10000 hrs
• Weight: 0.75 kg (1.65 lbs)
• Pump cycles only when fuel is demanded

• Current requirement: < 2 amps average
• Reverse polarity protected up to 60 minutes
• Self priming (dry lift) of more than 120cm (48")
• Dry run to four (4) hours
• Compatible with all commercially available pump grade petrol, gasohol, diesel or bio-diesel
• Operating temperature: -40 ~ +70°C (-40 ~ +155°F)
• Transient voltage protected to 100 volts
• U.S. Coast Guard 16623-1 and 16623-2 approved
• European CE Standards EN61000-6-2and EN 6-3-2100 approved